The Setup Steps; Jumper & Connector Setting - Procomp BVD2A Manual

BVD2A

2.3 The setup steps

refer to the following steps to setup your computer:
I. Refer to the Jumper Setup section to set up the jumpers appropriately.
II. Install the DIMM modules on the motherboard; be sure to install
them correctly.
III. Install the CPU on the motherboard (please refer to the CPU
installation manual).
IV. Choose a case and install the motherboard into the case.
V. Plug in all the interface cards of your system equipment.
VI. Connect cables, power supply and any message lines.
VII. Reboot, and enter the Award BIOS setup Menu to adjust the existing
setup to your needs.
VIII. Reboot, and set up the system software on your computer.
2.3-1 Jumper & Connector Setting
PS/2 Keyboard Connector
Use this connector to connect a PS/2 Keyboard.
Pin
1
3
5 Keyboard Clock
Description
Keyboard Data
Ground
~9~
Pin Description
2,6 N.C.
4 +5V