Procomp BVD2A Manual page 14

BVD2A
IrDA - Infrared Connector: IR
This connector is used to connect an infrared device.
Pin
1
2
3
4
5
WOL – Wake-up On LAN Connector
This connector is used to connect an add-in NIC (Network Interface
Card). When connected and enabled in the BIOS setup, this function can be
used for remotely managing a system on a network. When the LAN controller
detects activity on the network card, it will consequently wake up the system.
Pin
1
2
3
WOM – Wake-up On Modem Connector
Signal Name
VCC
-
IRRX
GND
IRTX
Signal Name
5VSB
GND
LID
~13~