Procomp BVD2A Manual page 27

BVD2A
Floppy Cable
The floppy cable for floppy disk drives is a 34-pin flat cable with 3
connectors classified as follows:
1. Female header (For floppy connector onboard)
2. Female header and Edge connector (For driver B)
3. Female header and Edge connector (For driver A)
The end-most connector cable is twisted to support floppy drive A, while the
middle connectors are for floppy drive B. The drive B connectors are designed
to accommodate both 1.44MB and 1.2MB drives. The female header supports
the 1.44MB drive, while the female edge connector supports the 1.2MB drive.
When connecting the drive, make sure that pin1 of the cable (ie., the
red-colored wire) matches pin1 of the drive.
IDE Cables for HDD and CDROM
The motherboard comes with two IDE interfaces; a primary IDE and a
secondary IDE connector. Each channel supports two IDE devices via a 40-pin
flat cable, thus enabling the system to accommodate a maximum of four
devices.
~26~