Changing the O-Rings of the Connecting Pieces
The O-rings of the connecting pieces should be changed every time the lower unit is dismounted.
1. Remove the O-ring from the connecting piece on
the side of the damping unit.
2. Put the O-ring protection tool onto the thread of
the connecting piece.
Required tool, see table on page 39
3. Slide the new O-ring onto its seat on the connec-
ting piece.
Required material, see table on page 39
4. Remove the tool.
5. Remove the O-ring from the connecting piece on
the side of the air spring.
6. Put the O-ring protection tool onto the thread of
the connecting piece.
Required tool, see table on page 39
7. Slide the new O-ring onto its seat on the connec-
ting piece.
Required material, see table on page 39
8. Remove the tool.
O.L / Single Shot 2 Forks - Technical Manual
47