Outside Lever Rehanding (Optional); Assemble Outside Adapter Plate And Rose; Install Outside Lever Assembly - Assa Abloy Sargent 8200 Series Installation Instructions Manual

BHL Trim
8200 Series
Installation Instructions
9

Outside Lever Rehanding (Optional)

a

Assemble Outside Adapter Plate and Rose

• Insert two (2) mounting posts into
adapter plate. (Figure 27)
• Install rose using four (4) security
Torx screws.
Note
Tighten screws evenly.
b

Install Outside Lever Assembly

• Insert spindle into bushing; ensure that spindle is inserted no more than ¾" deep.
• Use spindle to rotate bushing clockwise into outside lever hole.
• Fully tighten bushing, then unthread bushing just enough to allow spindle to be inserted into lever,
keeping bushing as tight as possible.
• Once assembled, spindle orientation should be as shown. (Figure 28)
Note
Longer spindle used on outside.
1-800-727-5477 • www.sargentlock.com
Copyright © 2019, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or
in part without the express written permission of SARGENT Manufacturing Company is prohibited.
RH Outside
LH Outside
Note position and orientation of spindles.
LHR Outside Shown
Adapter and Plate Assembly
with Mounting Posts
(4) Security Torx Screws
Figure 27
Make sure spindle seats into clutch
adapter, then proceed to step 4d to
retain Outside Trim on door.
Figure 28
11
RH/RHR Outside Shown
Rose Assembly
LH/LHR Outside Shown
A8131F 08/19