Lock Set Configuration; Rehanding Indicator (If Required) - Assa Abloy 8800 Series Installation Instructions Manual

8800 Series Mortise Lock
Used with Sectional Trim and V Series Indicators
Installation Instructions

3. Lock Set Configuration

To re-hand lock, see instructions on lock body.

4. Rehanding Indicator (If required)

Verify hand and bevel of door (Figure 2).
Figure 2
LH
LHRB
Left Hand
Left Hand
Hinges Left
Reverse Bevel
Open Inward.
Hinges Left
Open Outward.
NOTE: Stand on outside of locked door when determining door
hand.
Next, verify inside and/or outside indicators are handed correctly,
using Spindle Cam Position chart (Figure 3). If they are handed
correctly, skip to Step 5 "Prepare Door".
If they are not handed correctly:
1. Remove retaining pad and spindle cam from assembly
(Figure 4).
2. Position spindle cam in correct direction for door hand
(Figure 3).
NOTE: For thumbturn indicators, make sure thumbturn is
positioned in the 12 o'clock direction as shown (Figure 5).
3. Slide spindle cam post into correct slot of display slide
(Figure 4).
4. Re-seat retaining pad into original position.
5. Rerurn indicator to the vacant/unlocked position for
installation.
1-800-438-1951 • www.assaabloy.com
Copyright © 2020, 2023, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
RH RHRB
Right Hand Right Hand
Hinges Right Reverse Bevel
Open Inward. Hinges Right
Open Outward.
Figure 4
Display Slide
Figure 3
Spindle Cam Position for Locks with Deadbolt
Outside Indicator
Inside Indicator
Spindle Cam Position for Locks without Deadbolt
(*Does not include 8864 function)
Inside Indicator
Outside Indicator
Figure 5
Slot
Thumbturn
Position
Spindle Cam
Retaining Pad
3
(*Includes 8864 function)
Door Hand RH/RHRB
Inside Indicator
Door Hand LH/LHRB
Outside Indicator
Door Hand RH/RHRB
Outside Indicator
Door Hand LH/LHRB
Inside Indicator
80-8800-0016-000 10/23