Infineon PSoC 4 Quick Start Quide page 23

PSoC 4 Programming Using an External Microcontroller (HSSP)
Testing the Example Projects
2. Enter PSoC 5LP bootloader in the Pioneer kit:
Remove the power supply by unplugging the USB cable.
a)
Press and hold the reset switch (SW1) of the kit and plug in the USB cable.
b)
The status LED starts to blink, indicating that PSoC 5LP is in the bootloader mode.
PSoC 4 Pioneer Kit and the location of the status LED and reset switch.
Figure 6 PSoC 4 Pioneer Kit
3. Bootload the HSSP project to PSoC 5LP:
Open the bootloader host tool. Choose Tools>Bootloader Host in PSoC Creator.
a)
Click Filter, and then select the Show USB Devices checkbox.
b)
Enter '0xF13B' in the PID field (see
c)
PSoC 5LP bootloader is listed as USB Human Interface Device in the Port list.
Click Open in the GUI and select the B_Hssp_Pioneer.cyacd file from the following path:
d)
..\ AN84858 \ B_Hssp_Pioneer.cydsn \ CortexM3 \ARM_GCC_441 \Debug \B_Hssp_Pioneer.cyacd
Click Program to bootload the file to PSoC 5LP.
e)
Figure 7 Bootloader Host
Application Note
Figure 7).
23 of 45
Figure 6 shows the
001-84858 Rev. *N
2021-03-23