Infineon PSoC 4 Quick Start Quide page 27

PSoC 4 Programming Using an External Microcontroller (HSSP)
Testing the Example Projects
3. Bootload the HSSP project to PSoC 5LP:
Open the bootloader host tool. Choose Tools > Bootloader Host in PSoC Creator.
a)
Click on the Filter button, and then click on the Show USB Device' checkbox.
b)
Enter '0XF146' in the PID field.
c)
PSoC 5LP bootloader is listed as USB Human Interface Device in the Port list.
d)
Click Open the GUI and select the B_Hssp_Pioneer.cyacd file from the following path:
e)
..\ AN84858 \ B_Hssp_Pioneer.cydsn \ CortexM3 \ARM_GCC_441 \Debug \B_Hssp_Pioneer_2.cyacd
Click Program to bootload the file to PSoC 5LP.
f)
Figure 12 Bootloader Host Application
4. Install the USBUART driver for the kit:
Unplug and reconnect the USB cable.
a)
If Windows fails to install the USBUART drivers do the following:
b)
a. Open Device Manager. Make sure USBUART is present in the Other devices list.
b. Double-click the USBUART entry to open its properties.
c. Click Update Driver.
d. Select the Browse my computer for driver software option.
e. Navigate to the location where you saved the project attached with this application note, and
select the driver in the USBUART driver folder.
f. Click Next. Windows generates a warning because the driver files are not signed. Ignore the
warning and proceed. Now the USBUART driver is installed on your machine
5. Use HyperTerminal to start HSSP programming:
Open HyperTerminal on your computer. If you do not have it, download any terminal application for
a)
serial communication from the Internet.
In the UART configuration window, set the baud rate at 9600, data bits as 8, stop bits as 1, parity as No
b)
Parity, and Hardware Control as None.
Press any alphanumeric button on the keyboard to start programming. If the operation is successful, the
c)
terminal shows "HSSP Success".
Application Note 27 of 45 001-84858 Rev. *N
2021-03-23