Teaching The Analog Output - Leuze electronic ODS 10 Operating Instructions Manual

I [mA] U [V]
ca. 24 ca. 11
20 10
4 1
ca 2.5 0
A Area not defined
B Linearity not defined
C Measurement range
D Object present
E No object detected
F Measurement distance
Fig. 7.2: Behavior of analog output ODS10L1.8/L (factory setting)
7.1.2

Teaching the analog output

You can set the characteristic output curve for the analog output as follows:
• via the configuration menu
• via IO-Link
• via the Sensor Studio configuration software (see chapter 8 "Connecting to a PC – Sensor Studio")
Alternatively, you can teach the analog output using IO-Link commands or via the switching input (pin 5).
NOTICE
The teach-in described below is only possible for sensors with switching input.
Ä Activate teaching in the configuration menu via the OLED display and keyboard:
Input > Input Mode > Teach
NOTICE
Move through the configuration menu with the navigation button
Activate the desired selection with the enter button
Ä Position the measurement object at the desired distance.
Leuze electronic
0 30 50 8000 8500
.
ODS 10
Starting up the device
[
ca. 8500
.
]
34