Table of Contents
Advertisement
Status displays in process mode
Tab. 3.2:
Status displays on the display
Leuze electronic
Object distance in mm
No measurement value available, e.g. due to a weak or missing
reception signal; here due to the laser being switched off
No object detected or reception signal too weak
Sensor deactivated, laser switched off
• Via the input function (see chapter 3.4.1 "Input menu" and
see chapter 8.4.3 "CONFIGURATION function")
• Via the IO-Link command
The current measurement value is less than the lower limit
value of the analog output distance.
The current measurement value is greater than the upper limit
value of the analog output distance.
The measurement value has an offset
Level mode
e.g. fill level display: offset with falling gradient (-1)
Warning: Gradient is falling (-1); however, no offset is defined
Values < 0 are represented as 0
Lock function: Button lock activated via IO-Link (device access
locks, bit 2)
The button lock can also be enabled and set using the configu-
ration software Sensor Studio:
Configuration > Local operation
ODS 10
Device description
14
Advertisement
Table of Contents
