Table of Contents
Advertisement
6
Electrical connection
6.1
Overview
The assignment of the electrical connections is dependent on the type of sensor that is used. The type des-
ignation of the sensor is specified on the name plate.
Safety notices!
Ä Before connecting the device, be sure that the supply voltage agrees with the value printed
on the name plate.
Ä Only allow competent persons to perform the electrical connection.
Ä Ensure that the functional earth (FE) is connected correctly.
Fault-free operation is only guaranteed if the functional earth is connected properly.
Ä If faults cannot be rectified, take the sensor out of operation. Protect the sensor from acci-
dentally being started.
NOTICE
Protective Extra Low Voltage (PELV)
Ä The sensor is designed in accordance with safety class III for supply with PELV (protective
extra-low voltage).
NOTICE
For all connections (connection cable, interconnection cable, etc.), use only the cables listed in
the accessories (see chapter 13.2 "Accessories – cables and connectors").
6.2
Pin assignment
Pin assignment for ODS10L1.8/LAK-M12, ODS10L1.8/LAK,200-M12, ODS10L1-25M.8/LAK-M12
Fig. 6.1:
Pin assignment
Pin
Designation
1
18-30 V DC +
2
4-20 mA
3
GND
4
5
IN
Leuze electronic
CAUTION
Assignment
Supply voltage
Configurable analog output
• Current: 4 mA ... 20 mA
• Voltage: 1 V ... 10 V, 0 V ... 10 V
Factory setting: Current
Functional earth
IO-Link / switching output 1, push-pull
Function of the switching input
ODS 10
Electrical connection
30
Advertisement
Table of Contents
