Table of Contents
Advertisement
3.4.6
Settings menu
You can set the display language and call up information about the sensor in the Settings menu.
Level 1
Settings
3.4.7
Ending configuration
With IO-Link data storage, the configuration settings can be ended in the following ways.
Menu item
Exit menu
Exit DSUpld=1
Exit DSUpld=0
Leuze electronic
Level 2
Level 3
Language
English
German
Display
On
Auto
Auto off
Off
Factory settings
Inactive
Execute
Password Check
Inactive
Activated
Info
Part Number
Serial No
Firmware Re-
vision
Use
End
End if the change is to be en-
tered in the data memory. The
DSUpload flag is set.
End if the change is only tempo-
rary or no data memory is used.
The DSUpload flag is cleared.
Description
Setting of the display language
Note: If the display language is changed, this change only
becomes effective when the sensor is restarted.
Display language English
Display language German
Display settings
The display (measurement value dis-
play) is always at full brightness.
After pressing a control button, the
display is set to full brightness for
approx. one minute. The display is
then dimmed slightly for five minutes
and then dimmed considerably.
The display (measurement value dis-
play) is automatically switched off af-
ter approx. 6 minutes.
No measurement value display – the
display is only active in the menu af-
ter pressing a control button.
Reset to factory settings
The sensor is not reset to factory settings.
The sensor is reset to factory settings.
Locks access to the menu with the fixed password 165
Not active
Active
Information on the sensor
Leuze part number of the sensor
Serial number of the sensor
Firmware version
Display of the menu item
No change and the DSUpload flag is cleared
A change has been performed or the DSUpload
flag was already set.
A change has been performed or the DSUpload
flag was already set.
ODS 10
Device description
Default
X
X
X
21
Advertisement
Table of Contents
