Table of Contents
Advertisement
16-10-200716-10-2007
3.5
BREWER OPERATING SOFTWARE
Brewer Operating Software is provided on three 3.5" diskettes, with part numbers BA-E116, BA-
E118, and BA-U07, and will be installed in step 2. below.
Disk BA-E116 contains files in directories \ , \DOS , \BREWER, \UTIL, \UV-LAMP.
\ directory -- these are batch files, those with .BA_ extensions to be used as examples, and
those with .BAT extensions to be used to launch the BREWER and the NOBREWER
software.
\DOS directory -- these files are required to run the Brewer software, and some of its 'DOS'
functions.
\BREWER directory -- these files contain the MAIN Brewer operating program and all of the
routuines and data files necessary to control all of the Brewer command functions.
\UTIL directory -- contains some infrequently used utilities.
\UV-LAMP directory -- contains utilities specific to UV, such as for the generation of new UV
response files.
Disk BA-E118 contains a number of directories containing routines developed by various Brewer
users for specific applications. These routines are not supported by KIPP & ZONEN.
Disk BA-U07 contains files in directory \BDATA and subdirectory \BDATA\NNN (where NNN is the
Brewer number.)
\BDATA directory -- these files contain data collected during the testing of the instrument.
\BDATA\NNN -- these files contain firmware and software configuration information specific to
the Brewer whose Number (NNN) appears on the Disk identifier, as well as the utility used to
load firmware.
3.6
COMPUTER SETUP
This instruction assumes that KIPP & ZONEN has NOT supplied the Computer equipment. If KIPP
& ZONEN has supplied the Computer, then many of the following steps will have already been
completed, and need only be confirmed at this time.
Set up and interconnect the Computer and the Printer as per the Manufacturer's instructions,
1.
and confirm that the Printer prints when commanded to do so by the Computer.
Plug the Computer power cord into an AC Power Bar that has at least two additional outlets,
as they will be required in a later step.
Make copies of the Software Diskettes that came with the Brewer and use the copies in the
2.
following steps.
Inspect the contents of the three Diskettes labelled BA-E118, BA-116, and BA-U07 and copy
3.
the contents of these two diskettes into directories of the same names on the C: drive of the
Control Computer.
4.
Using the supplied AUTOEXEC.BA_ as a guide, and use a text editor to add pathing to the
AUTOEXEC.BAT file on the computer to include at least :
5. Use a text editor to display the OP_ST.NNN file in the C:\BDATA\NNN (NNN is the Brewer
Number). Note the third entry in the file - it will be a file name of the form ICFJJJYY.nnn.
C:\;C:\DOS;C:\BREWER;C:\BDATA
MKIV OPERATOR'S MANUAL
3. BREWER SYSTEM SETUP
27
Advertisement
Table of Contents
