Step 1: Uninstall Atp-2000 Panel Unit From Rack; Step 2: Panel Unit Disassembly - GRASS VALLEY ATP-2000 User Manual

Step 1: Uninstall ATP-2000 Panel Unit from Rack

1 Turn off the AC power to the ATP-2000 panel's power supply unit.
2 Disconnect the DC power lead to the ATP-2000 panel unit. 
(See
3 Remove the panel unit from the rack.
4 Place unit on an anti-static work surface.
Now proceed to

Step 2: Panel Unit Disassembly

Step 2.1: Removal of Micro SD Cards
Two micro SD cards are fitted into the micro SD card double-slot on the side-rear of the
unit. This may be under an adhesive label.
1 Locate the micro SD double-slot on the unit.
(See
2 Remove any covering label and retain it.
3 There are two micro SD cards fitted to the double-slot.
Fig. E-1: Micro SD Card(s) in Double-Slot
Both micro SD cards must be removed. Care must be taken when handling micro SD cards.
Repeat for each card present in the panel unit:
4 Select one of the micro SD cards and note which slot it is fitted to ("SD" or "BOOT").
5 Gently push the selected card inwards.
This will eject the card.
6 Remove the card, noting its orientation as you remove it. Tweezers may be required.
7 Keep the card in a safe place and remember its slot location.
8 Repeat for the other card.
Now proceed to
DC Power Connector, on page 55, for connector location.)
Step 2: Panel Unit
Micro SD Card Slots, on page 57, for slot location.)
IMPORTANT
It is important that each micro SD card is refitted into its original, correct slot.
The two micro SD cards must not be mixed up.
Step 2.2: Unit Disassembly.
Disassembly.
Micro SD Cards
ATP-2000
User Guide
63