Table of Contents
Advertisement
Notices
Display
Cleaning the Display Front
To clean a dirty display front, use an adhesion tape of the following type to lift any dirt off:
• Scotch Mending Tape No. 810 (for example, Scotch Magic
equivalent.
Mains Supply Voltage
Before connecting the ATP-2000 unit to a mains electricity supply with the Power Supply
Unit, observe the safety warnings section and ensure that the local mains supply is within
the rating stated on the rear of the Power Supply Unit.
xv
WARNING
Do not drop or knock the unit/display because the front is made of glass.
WARNING
If the display front glass is broken, do not inhale nor lick any internal
organic substance that may leak out. If any leakage touches your skin or
clothes, wash it off immediately using soap and plenty of water.
CAUTION
Do not apply pressure to the display surface nor to its surroundings
because the internal LCD cell structure of the display may be damaged.
CAUTION
Be careful when handling and touching the display because the
polarized front surface is soft and easily scratched.
CAUTION
Do not breathe upon a dirty display surface to clean it.
Do not wipe the display surface with a cloth.
Do not use any of the following solvents on the display surface:
• Water.
• Ketones (for example, Acetone).
• Aromatic Solvents.
WARNING
Class I Equipment. This equipment must be earthed. The power plug
must be connected to a properly wired earth ground socket outlet. An
improperly wired socket outlet could place hazardous voltages on
accessible metal parts.
TM
Tape 810), or an
Advertisement
Chapters
Table of Contents
