Starting Up - GRASS VALLEY ATP-2000 User Manual

Starting Up

The panel runs through its start-up sequence when power is applied. This lasts
approximately 1 minute.
During start-up, the unit briefly displays:
• an initial screen (see Figure 2-6a); followed by
• a splash screen (see Figure 2-6b); and, after start-up,
• a home screen (see Figure 2-6c).
a) Initial Screen
Panel unit information, including: Model number, IP address, and software version.
b) Splash Screen
c) Home Screen
Fig. 2-6: ATP-2000 Start-Up Screens: a) Initial Screen; b) Splash Screen; c) Home Screen.
When the ATP-2000 Advanced Touch Panel is showing its Home Screen in the rack, then its
rack installation is complete. (See
about the device's start up sequence.)
To get started, see
Note: An ATP-2000 panel ships with DHCP enabled. The panel requires a GV
Orbit system to have its DHCP facility enabled: On unit power up, an
IP address is then assigned automatically by GV Orbit.
Getting Started, on page 13.
Start-Up Sequence, on page 14, for more information
ATP-2000
User Guide
11