Preparing The Installation Site; Lifting And Positioning The Projector; Leveling The Projector - Christie Griffyn 4K32-RGB Installation And Setup Manual

• Adjustable wrench
• Step stool
• Powder-free N-DEX gloves
• Clean dry air (CDA)

Preparing the installation site

Ensure the installation area is ready for the components.
1. Clear the installation area.
2. Post laser hazard warning signs at all entry doors.
3. Place each component near its installation location.

Lifting and positioning the projector

Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
• Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
• Do not stack more than two projectors in landscape orientation.
1. If stacking the projector, ensure the bottom projector is level by adjusting the roll of the lens
axis to ensure the stability of the stack.
2. Position the projector so it is centered and parallel with the screen. If space is limited, aim the
projector slightly off-center and use lens offset to center the image on the screen.

Leveling the projector

Use the projector feet to level the projector.
1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the
bottom of the projector using the adjustable knobs on the feet.
Griffyn 4K32-RGB Installation and Setup Guide
020-103314-05 Rev. 1 (04-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
21