Christie Griffyn 4K32-RGB Installation And Setup Manual page 37

3. Select the corner sprite you want to adjust first.
By default the top-left position is selected.
4. Lock the color component of the sprite to align the other two color components to, and then
unlock one or both of the two remaining color components to adjust.
On the remote use keys 1 (red), 2 (green), and 3 (blue) to lock and unlock the color
components of the sprite.
Always align the color components of the sprite to the inner most line color (for each axis).
By default, all three color components (red, green, and blue) are displayed. It may be helpful
to obtain a better view of the position of a particular color component if one or two of the other
colors are deselected. On the remote, use keys 4 (red), 5 (green), and 6 (blue) to show or
hide the color components.
5. Move the red, green, and/or blue components for the selected sprite either horizontally (x-
axis) or vertically (y-axis) to align to the inner most line color.
On the remote, use the Up and Down keys to adjust vertically on the x-axis and the Left and
Right arrows to adjust horizontally on the y-axis.
To change the step size for the adjustment, on the remote select 7 (decrease) or 9 (increase).
The default is 1/8th of a pixel.
You cannot move the selected sprite outside the resolution range.
6. Repeat steps 4 and 5 for the other axis.
7. To apply the alignments and update the test pattern (so the effect is seen on the screen), on
the remote press and hold the Enter button.
A countdown is initiated and a message displayed when the alignments are applied.
8. To adjust remaining corners, repeat steps 3 to 7.
To move to the next corner, on the remote press Back. The Select Corner to Adjust dialog
appears. Use the arrow keys to select the next corner you want to adjust.
9. To save the convergence, on the remote press Test Pattern and select Save.
10. If the corner adjustment is not what you want, to start over reset the electronic convergence:
a) On the remote, press 0.
b) To reset the selected corner's alignment, select Selected.
c) To reset the alignments for all the corners, select All.
Griffyn 4K32-RGB Installation and Setup Guide
020-103314-05 Rev. 1 (04-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
37