Setting The Serial Interface - YOKOGAWA Vigilantplant mR10000 User Manual

3.5

Setting the Serial Interface

Procedure
3-14
The serial interface must be configured.
Setup Items
RS422/485 Address
End
For a description of the basic operations, see "Basic Key Operations" on page vi.
Entering Basic Setting Mode
Hold down the key for 3 seconds to display the Setting mode screen.
MENU
Next, hold down both the
display the Basic Setting mode screen.
Note
To cancel an operation, press the ESC key.
1. Press the key to select RS422/485 and then press the
Basic=RS422/485
2. Press the key to select the recorder's address and then press the
Address=1
3. Press the key to select the Baud rate value and then press the
Baud rate=38400
4 Press the key to select the Data length value and then press the
Data length=8
5 Press the key to select the Parity value and then press the
Parity=Even
6. Press the key to select the NORMAL or MODBUS value and then press
the key.
The setting complete screen appears.
Protocol=NORMAL
RS422/485
Setting complete
Saving the Settings
1. Press the ESC key to return to the Basic= screen.
2. Press the key to select End and then press the
3. Press the key to select Store and then press the
The settings are activated, and the Operation mode screen appears.
* When the key or
reversed as when the respective key is pressed by itself.
Baud rate Data length
Protocol
( ) key and the
DISP
key is pressed while holding down the SHIFT key, the operation is
Parity
( ) key for 3 seconds to
FUNC
key.
key.
key.
key.
IM 04P01B01-17E
key.
key.
key.