Names Of Parts And Basic Key Operations - YOKOGAWA Vigilantplant mR10000 User Manual

Names of Parts and Basic Key Operations

Display and Keys
IM 04P01B01-17E
You use the panel keys and the display to configure the communication functions. For a
description of other parts of the recorder, see section 3.1 in the Recorder User's Manual .
(The figure below is of the µR10000 Recorder.)
Front
Keys
<While setting functions, when the FUNC key/DISP MENU key is pressed>
CHARACTER Key: Changes the character type when entering a character. Press
this key while holding down the SHIFT key to switch the character type in reverse
order.
UP/DOWN Key: Switches the setup item or the value.
Press this key while holding down the SHIFT key to switch the setup item
or the value in reverse order.
LEFT/RIGHT Key: Moves the cursor to the right when entering a value
or character. Press this key while holding down the SHIFT key to move
the cursor to the left..
CHARACTER
RCD MENU DISP FUNC
FUNC key
Used when executing manual printout, message printout, etc.
DISP key
Switches the screen in the main display.
MENU key
Hold this key down for 3 seconds to enter Setting mode. Hold this key down for
3 seconds also to exit from Setting mode.
RCD key
Starts/stops recording.
Rear Panel
Display
Keys
Power
switch
ESC Key: Cancels the operation.
When pressed with the SHIFT key, the display of the comment
on the setting turns ON/OFF.
SHIFT Key: Used with the
CHARACTER key.
ENTER Key: Confirms the setup item or value.
ESC/? SHIFT
MENU FEED CH UP
1
CH UP key
Switches the displayed channel.
(when manual switching is specified)
FEED key
Feeds the chart paper.
DISP MENU key
Hold this key down for 3 seconds to switch to the data display
setup screen. Hold this key down for 3 seconds also to exit
from the data display setup screen.
Optional terminal block
Indicator
RS-422A/485
communication
Ethernet port
terminals
key, key, or the
<During normal operation>
v