Supply Installation; -48 V Dc Or Ac Power Supply; Dual Power Feed; Connector Pin-Out - JDS Uniphase OTU-8000 (EOTU8000E) User Manual

Chapter 3 Installation of the OTU-8000

Supply installation

Supply installation

-48 V DC or AC Power Supply

Dual power feed

Connector pin-out

24
The OTU-8000 can work with -48 V DC or AC.
The OTU-8000 is manufactured to work on a power supply from
-48V.
You need to wire your -48 V power source to the female 5-point
connector supplied with OTU-8000.
With AC power feed, you must install the converter delivered. In this
case, the female connector is already set into the converter.
1 Connect the female connector to the male connector on the OTU-
8000.
2 With the cord delivered with the converter (different according to the
country, see Figure 8 on page
If the LED onto the converter is solid green, the connection is
correctly performed.
On the OTU-8000 the LED Unit must be solid green.
Fig. 22 OTU-8000 with female connector and converter
If you wish to use the dual power feed feature of the OTU-8000, connect
2 -48 V DC power sources to the female connector (see
the pin-out).
The -48 V DC power supply connector pin-out is:
Table 4
Pin Number
User Manual 7OTU80050/01
7), connect the converter to a plug.
Female connector
Power on indicator
Power supply connector pin-out
Function
1
2 -48 VDC input A
3 Ground
4 -48 VDC input B
5
Table 4 to see
0
0