Chapter 3 ISDN PRA testing
Emulating an ISDN phone
Running the
30 call macro
Receiving and
disconnecting a
call
Accepting a call
78
The 30 call macro places 30 outbound calls. This verifies that
all channels are provisioned for placing calls.
To run the 30 call macro
1 Press the Actions soft key and then select 30 Call
Macro.
The HST-3000 places 30 individual outbound calls, one
on each channel.
2 To end the calls, press the Actions soft key and then
select Hang Up All Calls.
3 If you wish to cancel the macro before it finishes, press
the Actions soft key and then select Cancel Macro.
When a call comes in, the soft keys change to allow you to
accept, reject, or ignore each incoming call.
You can accept up to thirty calls on the HST. When you accept
a call, the call automatically connects to the microphone, and
the payload is dropped to the speaker. If you are using a
headset, the call connects to the headset, and the payload is
dropped to the headset speaker. To move between calls,
press the up or down arrow.
You can insert voice traffic into the B channel associated with
the call by speaking into the microphone or headset or you
can insert BER test patterns (see
page
81).
To accept a call when prompted
– Press the OK key or press the Answer soft key.
The HST-3000 accepts the call.
HST-3000 E1 Testing User's Guide
"Running a BER test" on