Cbam305 Cable; Usage; Dimensions; Fig. 8-9 Cbam305.1-0M6 Cable - Dimensions - ETAS FETK-S1.1 User Manual

ETAS
8.7

CBAM305 Cable

8.7.1

Usage

The CBAM305.1 FETK cable is a 1 GBit/s Ethernet cable adapter with external
power supply for FETKs.
Pre-assembled into PG9 screwing, shield connected to the screwing. It is
usable for ECUs without permanent power supply inside. Depending on the ver-
sion, there is a power plug on the ECU side or an open cable end on the power
cable:
• For thin walled housings, use a through boring with 15.2 mm in the hous-
ing and mount the cable with a nut (not included) (SM-PE 9 Order num-
ber 52103210 from Lapp).
• For wall thickness more than 4mm cut a thread into the housing.
If the CBAM305.1-2m2 is used, a 2 pin Erni connector (214011 or compatible)
must be available on the ECU as counterpart for the UBatt connector.
NOTE
It is recommended for safety reasons to connect the external permanent volt-
age and the switched voltage inside the ECU!
NOTE
For mounting the cable, cut a PG9 thread into the ECU housing. For thin
walled housings use a nut SM-PE 9. It is available from Lapp (order number:
52103210).
8.7.2

Dimensions

Fig. 8-9
FETK-S1.1 - User's Guide
CBAM305.1-0m6 Cable - Dimensions
Cables and Accessories
54