Installation; Connection To The Ecu; Fig. 5-1 Fetk-S1.1 Connection To The Ecu - ETAS FETK-S1.1 User Manual

ETAS
5

Installation

In this chapter, the hardware installation of the FETK-S1.1 is described.
Some components of the interface board may be damaged or destroyed by
electrostatic discharges. Please keep the board in its storage package until
it is installed.
The board should only be taken from its package, configured, and installed at
a work place that is protected against static discharge.
5.1

Connection to the ECU

Risk of short circuiting the internal signals of the FETK!
When you mount the FETK to the ECU, you must ensure that the screws and
washers used will not penetrate the FETK printed circuit board.
For connecting the FETK-S1.1 to the ECU two FETK adapter cables are recom-
mended:
• at CON1 adapter cable ETAM8A or ETAM8B
• at CON2 adapter cable ETAM2 or ETAM5
For additional details to connect the FETK-S1.1 to the ECU with adapter cables
see Fig. 5-2.
The adapter cables are to be ordered separately (refer chapter "Ordering Infor-
mation" on page 66).
Fig. 5-1
FETK-S1.1 - User's Guide
CAUTION
CAUTION
FETK-S1.1 Connection to the ECU
ETAM2 or ETAM5
FETK-S1.1
ETAM8
Installation
29