Introduction; Applications; Fetk-S1.1 - ETAS FETK-S1.1 User Manual

ETAS
3

Introduction

This section contains information about the basic features and applications of
the FETK-S1.1 Interface Board (FETK = Emulator Test Probe for the ETAS
ES89x ECU and Bus Interface Modules), hints to system requirements for oper-
ating the FETK-S1.1, and other details.
3.1

Applications

The FETK-S1.1 is an emulator probe for the Infineon AURIX microcontroller
family. It is a serial FETK designed for use with the DAP interface (IEEE/ISTO
5001).
NOTE
For supported Infineon AURIX microcontrollers, refer to chapter 7.1.3
on page 36.
Fig. 3-1
ECU interface connector
Power supply connector
Power supply for ED devices (VDDS-
BRAM)
SBRAM sense
Pinless triggering
Timer triggering
To access the ECU the FETK-S1.1 has to be connected via ES89x modules.
The system can be used for high speed Measurement, Calibration and ECU
flash programming. Support of Rapid Prototyping applications e.g. functional
prototyping - bypass depends on the functionality of the connected modules.
The FETK-S1.1 and ES89x system uses the standardized protocol "XCP on
Ethernet" for PC communication. Thus 3rd party tools can be connected to the
ECU as well.
FETK-S1.1 - User's Guide

FETK-S1.1

FETK-S1.1
20 pin FCI
6 pin MOLEX
min. 1.3 V
Yes
Yes
Yes
Introduction
16