Connect Work Lights - ETC ColorSource Raceway Installation Manual

Connect work lights

Images in this section show the suspended mount brackets, but you connect the work light in the same
way for any of the brackets that include mounting hardware for work lights.
Note:
1: Connect the work light to the ColorSource Raceway using the attached cable (see image below).
2: Are you mounting the ColorSource Raceway to FlyPipe?
• Yes—Continue to step 4.
• No—Attach the provided cable guide bushings to the work-light cable. Position the two
bushings in the openings in the transition-box base, and coil any excess cable in the transition
box.
1: Connect the
work light to
ColorSource
Raceway
Installation
If you are using grid mount brackets or suspended mount brackets, you should have
already installed a transition-box base on the bracket that will support the work light.
You will use the transition box to store the excess cord connecting the work light to
the ColorSource Raceway. If you did not install a transition-box base, return to the
appropriate bracket installation instructions and install the transition-box base on the
bracket:
• Grid mount bracket: See
• Suspended mount bracket: See
or Prodigy RACA mount
Grid mount on page 13.
Suspended mount, Dual batten suspended mount,
on page 19.
2: Position the
cable guide
bushings in the
box openings
29