Suspended Mount, Dual Batten Suspended Mount, Or Prodigy Raca Mount - ETC ColorSource Raceway Installation Manual

Suspended mount, Dual batten suspended mount, or
Prodigy RACA mount
The illustrations in this section show the suspended mount, but the installation steps are the same for
the suspended mount, the dual suspended mount, and the Prodigy RACA mount.
1: Identify the locations where the ColorSource Raceway will be supported, and align the hanger
brackets to the closest positions. Suspended-mount hanger brackets or Prodigy RACA mount
hanger brackets must be aligned in between faceplates (see image below).
The hanger bracket that supports the termination box differs from the other brackets (see image
below). Make sure to position the appropriate hanger bracket at the termination box.
2: Will the hanger bracket support a work light?
• No—Continue to step 3.
• Yes—Attach the transition-box base to the front piece of the bracket as shown below. Set
aside the transition-box cover and remaining hardware. You will use the transition box to
store the excess cord connecting the work light to the ColorSource Raceway. See
work lights
Transition box
(both base and
cover shown)
Installation
Align bracket
between faceplates
page 29
on .
Make sure that the opening is
at the bottom before attaching
box to hanger bracket
Hanger bracket Termination box
hanger bracket
Attach transition-box
base to hanger bracket
Connect
19