Attach Work Lights To Prodigy Flypipe - ETC ColorSource Raceway Installation Manual

Attach work lights to Prodigy FlyPipe

1: Identify the location of the work-light connectors on the ColorSource Raceway. You will attach
the work lights to the FlyPipe near the connector.
2: Attach the mounting hardware to the work lights, but do not tighten.
CAUTION:
3: Insert the Unistrut nut into the bottom of the FlyPipe, and then turn the nut 90 degrees and set
it into the FlyPipe tracks (see images below).
4: Tighten the bolt to secure the work light. Then continue to
3: Insert nut, and
then rotate
90 degrees
26
2: Attach mounting
hardware, but
do not tighten
Using channel hardware with springs can cause severe damage to FlyPipe.
ETC recommends using channel nuts without springs.
(Work light cable
not displayed)
Connect work lights
3: Set nut
into tracks
ColorSource Raceway Installation Manual
page 29
on .
4: Tighten
bolt