Table of Contents
Advertisement
• Ethernet—Strip the end of the outer cable jacket on the incoming cable (Cat5e cable or
better). Gently pull out the ethernet junction box and remove the cover. Then punch down
the individual wires into the "B" labeled positions according to the labeled colors using a
110 punch-down tool (see image below). Replace the ethernet junction box cover, and then
replace the junction box in the termination box. Continue to step 7.
7:
Re-install the cover on the termination box and secure it with the four screws.
8:
Re-install any bracket that is secured over the termination box.
Connector versions
The ColorSource Raceway termination box can support the following connector combinations:
• LKS Data connector
• Socapex connector + 5-pin XLR connector
• Socapex connector + RJ45 connector
Connect the appropriate cables to the connectors on the ColorSource Raceway termination box.
Connect power and data
Punch down incoming wires:
1 = White/Orange
2 = Orange
3 = White/Green
4 = Blue
5 = White/Blue
6 = Green
7 = White/Brown
8 = Brown
A
A
B
B
A
A
Ethernet
junction
box
33
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource Raceway and is the answer not in the manual?
Questions and answers