T e r m i n a ti o n B o a r d I n s t a l l a t i o n
Each Desire D40XTI Series fixture is connected to the network through a Termination
board which is installed in a junction box that is suitable for outdoor use. The DMX cable
from the fixture is connected to the Termination board.
T e r m i n a ti o n
The Desire D40XTI Series requires that the last fixture on a DMX/RDM line be terminated
with a 120 ohm resistor, which is accomplished with the S1 switch on the Termination
board. Set the switch to the ON position to terminate the last fixture. All others on the
DMX/RDM line must be set to OFF.
Indi cator Lights
The indicator lights on the back of Desire D40XTI Series fixture show the status of power
input (blue), DMX input (green) and fixture errors (red). When the DMX/RDM signal is lost,
the green indicator flashes. For more information, refer to
Figure-1.4 Indicator lights on the Desire D40XTI Series fixture.
1
Installation and DMX Profiles
Status Indicators, page
33.
19