Attach Batten To Hanger Brackets; Attach Work Lights To Hanger Brackets - ETC ColorSource Raceway Installation Manual

Attach batten to hanger brackets

1: Lay the batten in the hanger brackets. Ensure that the batten is positioned with the internal
support in a vertical orientation. (Witness lines on the batten should be positioned on the top
and bottom of the batten.)
2: Attach the batten clamp hardware and secure it using the provided carriage bolts and nuts.
3: Install the self-drilling screw at the center of each hanger bracket to prevent the batten from
rotating.
1: Verify
orientation
of batten
2: Secure
bracket
4: If you are using the dual batten suspended mount, repeat steps 1–3 to attach the second batten
to the hanger brackets.

Attach work lights to hanger brackets

1: Attach the mounting hardware to the work lights.
Installation
3: Install
self-drilling
screw
Batten hardware,
side view
1: Attach mounting
hardware
Finished batten bracket, front and back view
(Work light cable
not displayed)
23