Table of Contents
Advertisement
Figure 91. Installing an expansion card into Riser 1
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
After working inside your system
on page 24.
3. Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
Safety instructions
on page 23.
2. Follow the procedure listed in the
Before working inside your system
on page 24.
3. Remove the BOSS card. The BOSS card removal is similar to
removing expansion card from the expansion card
riser.
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the BOSS card connector.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
86
Installing and removing system components
Hide quick links:
Advertisement
Table of Contents
