Steps
1. Slide the drive carrier into the drive slot.
2. Close the drive carrier release handle to lock the drive in place.
Figure 34. Installing a drive carrier
Next steps
If removed,
install the front
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
3.
Remove the drive
carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) screwdriver to remove the drive.
2. Lift the drive out of the drive carrier.
bezel.
Safety instructions
bezel.
on page 23.
Installing and removing system components
43