Control Panel; Removing The Right Control Panel - Dell EMC PowerEdge XE8545 Installation And Service Manual

Next steps
1. Install the following components:
a. System board.
b. Power supply units
c. OCP card (if installed).
d. Processor.
e. Heat sink.
f. Memory modules.
g. Cooling fan cage assembly.
h. Air shroud.
i. Nvidia A100 GPU assembly.
j. GPU air shroud.
k. Middle top cover.
2. Connect any cables which were previously disconnected from the components.
3. Follow the procedure listed in

Control panel

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the middle top
4. Remove the air shroud.
5. Remove the cooling fan
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the 16 screws that secure the front top cover and the four screws securing the
right control panel.
114 Installing and removing system components
(PSU).
After working inside your system
Safety instructions
Before working inside your system
cover.
assembly.
bracket.
on page 24.
on page 23.
on page 24.