Installing The Ocp Card - Dell EMC PowerEdge XE8545 Installation And Service Manual

Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
Figure 98. Removing the OCP card
4. If the OCP card is not going to be replaced, install a filler bracket .
Next steps
Replace the OCP card.

Installing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the expansion card
Steps
1. If installed, remove the filler bracket.
2. Open the blue latch on the system board.
3. Slide the OCP card into the slot in the system.
4. Push until the OCP card is connected to the connector on the system board.
5. Close the latch to lock the OCP card to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
92 Installing and removing system components
Safety instructions
Before working inside your system
riser.
on page 23.
on page 24.