Figure 108. Removing the Rear IO card and LOM card
Next steps
Replace the Rear IO card and LOM
Installing the Rear IO card and LOM card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Align the connectors and slots on Rear IO card and LOM card with the connector and standoffs on the system board.
2. Press the Rear IO card and LOM card until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the Rear IO card and LOM card to the system board with the two screws.
card.
Safety instructions
Before working inside your system
on page 23.
on page 24.
Installing and removing system components
103