Dell EMC PowerEdge XE8545 Installation And Service Manual page 64

CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the
memory module or metallic contacts.
2. If a memory module is installed in the socket, remove it.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
NOTE: Ensure that the memory socket ejectors are fully open.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both ends of the
memory module evenly.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do
not bend or flex the memory module. Insert both ends of the memory module simultaneously.
4. Press the memory module with your thumbs until the ejectors firmly click into place. When the memory module is properly
seated in the socket, the levers on the memory module socket align with the levers on the other sockets that have memory
modules that are installed.
Figure 61. Installing a memory module
Next steps
1. If removed, install the air
2. Follow the procedure listed in
3. To verify if the memory module has been installed properly, press F2 and go to System Setup Main Menu > System BIOS
> Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the
installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the
memory modules are firmly seated in their sockets.
5. Run the system memory test in system diagnostics.
64 Installing and removing system components
shroud.
After working inside your system on page 24.