Side Wall Brackets; Removing The Side Wall Bracket - Dell EMC PowerEdge XE8545 Installation And Service Manual

3. Press the release levers to lock the cooling fan cage assembly into the system.
Figure 30. Installing the cooling fan cage assembly
Next steps
1. Install the air shroud.
2. Follow the procedure listed in

Side wall brackets

Removing the side wall bracket

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the middle top
4. Remove the GPU air shroud.
5. Remove the air shroud.
6. Remove the cooling fan
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Press the tab to open the side wall bracket cover.
NOTE: Unroute the cables to release them from the side wall bracket.
2. Lift the bracket to release it from the chassis.
NOTE: The procedure is same for both the side wall brackets.
After working inside your system
Safety instructions
Before working inside your system
cover.
assembly.
on page 24.
on page 23.
on page 24.
Installing and removing system components 39