Installing The Hot-Plug Fan Board - Dell EMC PowerEdge XE8545 Installation And Service Manual

5. Remove the middle top
6. Disconnect the drive backplane cables from the connector on the backplane.
7. Remove the GPU air shroud.
8. Remove the Nvidia A100 GPU assembly.
Steps
1. Disconnect the cables that are connected to the hot-plug fan board.
2. Pull the plungers to disengage the hot-plug fan board and lift it out of the system.
Figure 57. Removing the hot-plug fan board
Next steps
Replace the hot-plug fan

Installing the hot-plug fan board

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the front
4. Remove the GPU fans.
5. Disconnect the drive backplane cables from the connector on the backplane.
6. Remove the middle top
7. Remove the GPU air shroud.
8. Remove the Nvidia A100 GPU assembly.
Steps
Align the hot-plug fan board to the hooks on the chassis and lock the plungers to secure the hot-plug fan board to the system.
cover.
board.
Safety instructions
Before working inside your system
bezel.
cover.
on page 23.
on page 24.
Installing and removing system components 59