Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the expansion card
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guides on the intrusion switch module with the standoffs on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
4. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 97. Installing the intrusion switch module
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Safety instructions
Before working inside your system
riser.
riser.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 23.
on page 24.
on page 24.
on page 23.
on page 24.
Installing and removing system components
91