Cruise Control (If Fitted); Automatic Transmission; Cruise Control Switches - Lotus Evora 400 2018 Owner's Handbook Manual

AUTOMATIC TRANSMISSION

CRUISE CONTROL SWITCHES

Cruise Control (If Fitted)

WARNING
Use cruise control only when conditions
are favourable; on straight, dry, open
roads with light traffic.
Note: The system cannot be activated below
28 mph (45 km/h) or above 130 mph (210
km/h), or in first or second gear.
Cruise control modes are:
- Off.
- Enabled (but inactive).
- Active.
To enable cruise control
With the ignition on or engine running
press the button; the
instrument panel will light to confirm that
the system is enabled (although no speed
has yet been set).
68
E132T0324JA Federal Evora 400 From SOP OHB English Language.indd 68
Alternatively, this operation may be com-
bined with that for activation, by pressing
the button followed by the
To activate cruise control:
With the system enabled drive the car to the
desired speed and press the
accelerator may now be released and the
set speed maintained (road gradient and
winds permitting). The accelerator may be
used to increase speed temporarily without
affecting the setting.
Changing the cruise setting
Whilst cruise is active, the speed setting
can be adjusted by:
- Holding down the
celerate/decelerate the car to the desired
new speed. On release of the button, that
speed is set.
- Repeated short presses of
buttons to increase or decrease the set-
ting by increments of 0.6 mph (1 km/h).
Returning to enabled (but inactive) mode
This will occur with any of the following
actions:
- The brake or clutch pedal is depressed;
- The button is pressed.
tell tale in the
In any of these cases, normal manual speed
control will be restored, but the system will
remain enabled and the
remain illuminated.
+
button.
Resuming cruise control
Press the
automatically accelerate or decelerate to
+
button. The
the last activated set speed.
The resume function should be used only
if you want to return to and are aware of
the set speed.
Set speed cancellation
The set speed will be reset to zero when
you disable cruise control (from the enabled
_
state) or if the ignition is switched off.
+
or buttons to ac-
To turn off cruise control
Press the
_
state or twice from the active state and the
+
cruise control tell tale will extinguish.
the or
tell tale will
button. The vehicle speed will
WARNING
button once from the enabled
15/08/2018 14:47:22