Quick Start Wizard Via Ams Device Manager - Siemens SITRANS LR250 Operating Instructions Manual

Quick Start Wizard via AMS Device Manager

The Quick Start Wizard groups together all the settings you need to configure a device for
most applications.
Please consult the operating instructions or online help for details on using AMS Device
Manager.
Note: Use Quick Start Wizard via AMS Device Manager for initial configuration of a
device on an FF network. If device is not on an FF network, initial configuration should
be completed via the Quick Start Wizard from the LUI. (See
Quick Start Wizard steps
Notes:
• Complete the steps in order. Click on Apply after revising parameters in each step,
or CANCEL to exit step without saving changes. (Note: Apply will write changes to
the device. OK will write changes to the device and exit to the Device Connection
View. CANCEL will exit to the Device Connection View without applying changes.)
• Do not use the Quick Start Wizard to modify individual parameters: see instead
Changing parameter settings using AMS Device Manager on page 49
customization only after the Quick Start has been completed.)
• Values set using the Quick Start Wizard via AMS Device Manager are saved and
recalled each time it is initiated (unlike the Quick Start Wizard initiated via the
handheld programmer).
• To run the Quick Start Wizard for this device, the RESOURCE block must first be set
to Out of Service (OOS) mode, before any configuration changes (changes to
parameters affecting block output) can be written. (Setting RESOURCE block to OOS
also sets LTB to OOS.)
• After completing steps 1-4, review all settings in
steps1-4 if further changes are required.
• After completing the Quick Start Wizard from AMS, you must manually place the
RESOURCE block in Automatic mode.
Launch AMS Device Manager and double-click the device icon from the Device
Connection View to open the startup screen. Navigate to Configure/Setup > Resource
Block > Wizards > Quick Start, and click on Step 1 - Identification.
7ML19985KL01 SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
Quick Start
on page 30.)
. (Perform
Step 5 - Summary
. Return to
Page 45