Configure/Setup (Diagnostic Transducer Block-
DIAG)
Note: Parameters in the Diagnostic Transducer Block used solely by factory personnel.
Identification (DIAG)
Navigate to Configure/Setup > DIAG > Identification.
Identification:
•
TAG
•
Descriptor
•
Transducer Block Type
•
Strategy
•
Plant Unit
Note: For descriptions of Identification parameters see
Operation (DIAG)
Navigate to Configure/Setup > DIAG > Operation.
Block Modes:
•
Actual Mode
•
Target Mode
•
Permitted Mode
•
Normal Mode
Note: For descriptions of Block Modes see
Communication (DIAG)
Navigate to Configure/Setup > DIAG > Communication.
Communication:
•
Static Revision No. (see
7ML19985KL01
2.6.1. Static Revision Number
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
Identification: on page 49
Block Modes: on page 50
.
.
on page 113)
Page 65