Siemens SITRANS LR250 Operating Instructions Manual page 43

Material
Selects the appropriate echo processing algorithms for the material (see Position
Detect (2.5.7.2.) on page 146 for more detail).
Options
Response Rate
Sets the reaction speed of the device to measurement changes in the target range.
Options
Use a setting just faster than the maximum filling or emptying rate (whichever is
greater).
Units
Sensor measurement units.
Options
Low Calibration Point
Distance from Sensor Reference to Low Calibration Point: usually process empty
level. (See Calibration 2.3.7. on page 99 for an illustration.)
Values
High Calibration Point
Distance from Sensor Reference to High Calibration Point: usually process full level.
(See Calibration 2.3.7. on page 99 for an illustration.)
Values
Wizard Complete
Note:
Wizard Complete is only displayed on the device when using the handheld
programmer. This step is not part of the Quick Start Wizard when using AMS Device
Manager.)
In order to save the Quick Start settings it is necessary to select FINISH to apply
changes.
Options
Press Mode
now be operational. To view a measurement reading over the network, one of the Analog
Input Function Blocks (AIFB) will need to be setup and scheduled using a network
configuration software tool.
7ML19985KL01
* LIQUID
LIQUID LOW DK (low dielectric liquid – CLEF
enabled
Response
Rate (2.3.8.1.)
* SLOW
MED
FAST
M, CM, MM, FT, IN
Default: M
Range: 0.0000 to 30.000 m
Default: 20.000 m
Range: 0.0000 to 30.000 m
Default: 0.000 m
BACK, CANCEL, FINISH (Display returns to 1.1 Quick Start Wizard menu
when Quick Start is successfully completed.)
to return to Measurement mode. The Level Transducer Block (LTB) will
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
)
Fill Rate per Minute (2.3.8.2.)/Empty Rate
per Minute (2.3.8.3.)
0.1 m/min (0.32 ft/min)
1.0 m/min (3.28 ft/min)
10.0 m/min (32.8 ft/min)
algorithm
Page 37