Programming; Programming The Radar Device; Quick Start Wizard Via The Handheld Programmer - Siemens SITRANS LR260 Operating Instructions Manual

6.2.3

Programming

6.2.3.1

Programming the radar device

Note
● While the device is in PROGRAM mode the output remains fixed and does not respond to
changes in the device.
● The device automatically returns to Measurement mode after a period of inactivity in
PROGRAM mode (between 15 seconds and 2 minutes, depending on the menu level).
6.2.3.2

Quick Start Wizard via the handheld programmer

Note
● A reset to factory defaults should be performed before running the Quick Start Wizard if the
device has been used in a previous application. See Master Reset (4.1.).
● The Quick Start wizard settings are inter-related and changes apply only after you
select Finish in the Wizard Complete step.
● Do not use the Quick Start wizard to modify parameters: see instead Parameter Reference
(Page 73). (Perform customization for your application only after the Quick Start has been
completed).
● Default settings in the parameter tables are indicated with an asterisk (*).
1. Quick Start
1.1. Quick Start Wiz
● Point the programmer at the display from a maximum distance of 500 mm (1.6 ft), then
press RIGHT arrow
● Press RIGHT arrow
● Press RIGHT arrow
● To change a setting, scroll to the desired item or key in a new value.
● After modifying a value, press RIGHT arrow
move to the next item.
● The Quick Start Wizard settings are inter-related and changes apply only after you click
on Yes in Apply? at the end of the Quick Start steps.
SITRANS LR260 with mA/HART
Operating Instructions, 11/2019, A5E32337683-AD
to activate PROGRAM mode and open menu level 1.
twice to navigate to menu item 1.1 and open parameter view.
to open Edit mode or DOWN arrow
6.2 Local commissioning
to accept default values.
to accept it and press DOWN arrow
Commissioning
to
51