Quick Start; Setup; Identification; Device - Siemens SITRANS LR250 Operating Instructions Manual

1. Quick Start

For detailed instructions see Quick Start Wizard via the handheld programmer
Note:
on page 36 or Quick Start Wizard via AMS Device Manager on page 45.

2. Setup

Notes:
• See Enter PROGRAM mode on page 33 or
page 40 for instructions.
• Default settings in the parameter tables are indicated with an asterisk (*) unless
explicitly stated.
• Values shown in the following tables can be entered via the handheld programmer.

2.1. Identification

2.1.1. Tag
Read only. Text that can be used in any way. A recommended use is as a unique
label for a field device in a plant. Limited to 32 ASCII characters.
Note:
Configurator or DeltaV.
2.1.2. Descriptor
Read only. Text that can be used in any way. Limited to 32 ASCII characters. No
specific recommended use.
To access this parameter via AMS Device Manager see Identification under
Identification (RESOURCE)
2.1.3. Message
Read only. Text that can be used in any way. Limited to 32 ASCII characters. No
specific recommended use.
To access this parameter via AMS Device Manager see Identification under
Identification (RESOURCE)

2.2. Device

2.2.1. Hardware Revision
Read only. Corresponds to the electronics hardware of the Field Device.
2.2.2. Firmware Revision
Read only. Corresponds to the software or firmware that is embedded in the
Field Device.
2.2.3. Loader Revision
Read only. Corresponds to the software used to update the Field Device.

2.3. Sensor

2.3.1. Unit
Sensor measurement unit.
Values
7ML19985KL01
The tag can only be changed from a remote master such as NIFBUS-
on page 66
on page 66
m, cm, mm, ft, in
m
*
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
Operating via AMS Device Manager
.
.
on
Page 97