Ce Electromagnetic Compatibility (Emc) Conformity; Industry Canada - Siemens SITRANS LR250 Operating Instructions Manual

CE Electromagnetic Compatibility (EMC) Conformity

This equipment has been tested and found to comply with the following EMC Standards:
EMC Standard
CISPR 11:2004/EN
55011:1998+A1:1999&A2:2002, CLASS B
EN 61326:1997+A1:1998+A2:2001+A3:2003
(IEC 61326:2002)
EN61000-4-2:2001
EN61000-4-3:2002
EN61000-4-4:2004
EN61000-4-5:2001
EN61000-4-6:2004
EN61000-4-8:2001

Industry Canada

a) Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
b) This device shall be installed and operated in a completely enclosed container to
prevent RF emission which otherwise can interfere with aeronautical navigation.
Installation shall be done by trained installers, in strict compliance with the
manufacturer's instructions.
c) The use of this device is on a "no-interference, no-protection" basis. That is, the
user shall accept operations of high-powered radar in the same frequency band
which may interfere with or damage this device. On the other hand, level probing
devices found to interfere with primary licensing operations will be required to be
removed at the user's expense.
Page 2 SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
Title
Limits and methods of measurements of radio
disturbance characteristics of industrial, scientific,
and medical (ISM) radio-frequency equipment.
Electrical Equipment for Measurement, Control and
Laboratory Use – Electromagnetic Compatibility.
Electromagnetic Compatibility (EMC) Part 4-2:Testing
and measurement techniques – Electrostatic
discharge immunity test.
Electromagnetic Compatibility (EMC) Part 4-3:
Testing and measurement techniques – Radiated,
radio-frequency, electromagnetic field immunity test.
Electromagnetic Compatibility (EMC) Part 4-4:
Testing and measurement techniques – Electrical
fast transient/burst immunity test.
Electromagnetic Compatibility (EMC) Part 4-5:
Testing and measurement techniques – Surge
immunity test.
Electromagnetic Compatibility (EMC) Part 4-6:
Testing and measurement techniques – Immunity to
conducted disturbances, induced by radio-frequency
fields.
Electromagnetic Compatibility (EMC) Part 4-8:
Testing and measurement techniques – Power
frequency magnetic field immunity test.
7ML19985KL01