Xilinx Virtex-7 FPGA VC7203 Getting Started Manual page 38

Chapter 1: VC7203 IBERT Getting Started Guide
14. Synthesize the partitioned IBERT core only. To do this, right-click the IBERT synthesis
X-Ref Target - Figure 1-31
15. When the synthesis is done, click Run Synthesis in the Flow Navigator, which
16. When that synthesis is done, a Synthesis Complete window pops up. Select Open
38
run in the Design Runs window under Module Analysis Runs and select Launch
Runs (Figure 1-31). In the Launch Selected Runs window, leave the defaults
unchanged and click OK.
Figure 1-31: Synthesize IBERT Partition
synthesizes the rest of the design.
Synthesized Design and click OK
www.xilinx.com
(Figure 1-32).
VC7203 IBERT Getting Started Guide
UG847 (v3.0) July 10, 2013