Settings, Menu - Kessel Control Unit Ecolift 230V Instructions For Installation, Operation And Maintenance

3.6.

Settings, menu

General information
The menu prompting has an operating and a standby mode.
In operating mode the system settings can be displayed and adjusted on the display (refer also to 5.2 Menu
structure).
If over a period of approx. 60 seconds none of the keys are pressed, standby mode is activated automatically, the
background lighting of the display is then switched off.
Navigation keys for the menu
22 Cursor up
23 Cursor
down
24 ESC
25 OK
Activating operating mode
• Press the OK key <25> on the control panel,
background lighting of the display lights up and the
start screen System info <38> (Fig. [13]) is displayed
• Press OK <25>, level 1 of the menu
(see 5.2 Menu structure) is activated.
Note: The display can vary depending on the configuration
Navigation within the menu
Action
Select menu item
Activate menu point for editing
Display or edit set value
Quit menu
INSTALLATION
Scrolling in the menu
Scrolling in the menu
Deletion of an entry, back
Confirmation of an entry, next level
Operation
Cursor up / cursor down, selected menu item is shown inverted
OK. If a menu sub-item exists, this is shown inverted.
OK, value is displayed or shown inverted for setting
ESC, leave current level, moves up a level
32/120
24
23
[12]
38
Datum --,--,--
Uhrzeit
--,--,--
Niveau:
-- mm
Pumpe I:
Aus
Pumpe II:
Aus
Fehler/Meldung/Ereignis (Statuszeile)
[13]
22
25
2016/02