Connectors - Analog Devices ADSP-2189M EZ-KIT Lite Manual

Table 3-1. Mode Selection Switches
SW3
1
2
3
4
CONFIGURATION TYPE 5
SW3
1
2
3
4
CONFIGURATION TYPE 5

Connectors

This section describes headers and connectors supplied with this EZ-KIT
Lite.
• The
J1
used to bring either line level or microphone audio signals into the
board.
• The
J2
used to bring out line level audio signals from the board.
ADSP-2189M EZ-KIT Lite Evaluation System Manual
BDMA feature is used to load the first 32 program memory
words from the byte memory space. Program execution is held
8 MODE D = 1
off until all 32 words have been loaded. The ADSP-2189M is
7 MODE C = 1
configured in Host Mode;
pull-down. (Note: Requires additional hardware).
6 MODE B = 0
5 MODE A = 0
IDMA feature is used to load any internal memory as desired.
Program execution is held off until internal program memory
8 MODE D = 1
location 0 is written to. The ADSP-2189M is configured in
7 MODE C = 1
Host Mode.
6 MODE B = 0
5 MODE A = 1
connector is a 1/8 inch (3.5 mm) stereo jack. This jack is
connector is a 1/8 inch (3.5 mm) stereo jack. This jack is
EZ-KIT Lite Hardware Reference
requires an external
IACK
requires an external pull-down.
IACK
3-7